Hp Network Discovery Tool
To find and maintain HP Networking devices, HP recommends using the HP Network Discovery Tool. Note that this tool does not replace or augment full-featured HP Network Management software.
To install the HP Network Discovery Tool follow these steps:
From a PC (running Windows Vista SP2, Windows 7 SP1, 8, 2008 SP2 or R1 SP1, or later), type in the URL* for the HP Network Discovery Tool into a browser’s address field and press Enter.
When asked, open the file. In the resulting folder, double-click on the file setup. Accept running the install.
Upon completion, the tool should run automatically. (Note: If .NET is not installed on your system, you may be prompted to install it. Follow the installation instructions.)
- Lldp is the Link Layer Discover Protocol. The SysName column will display the host name of the remote switch. To map out your network, you will start at an edge switch, run these commands, then ssh to those remote switches. Once on the remote switch, repeat this process.
- Network device discovery vs. PC-connected discovery Both PC-connected and network-connected device discoveries result in devices added to the All Devices list. Network devices, when discovered, are manageable from within HP Web Jetadmin.
*For additional information, contact http://www.hp.com/networking/support.
IMPORTANT: When updating the HP Network Discovery Tool software, you must first uninstall the old version before installing the new one. |
Cisco Network Discovery Tool
Using the software, you can also modify the basic network information including IP address, subnet mask, gateway, etc. Attention: Supprt Mac OS 10.10 and above version. Remote Backup Software Description: Remote Backup software can back up the video files stored in the device and save the video files to the local disk. The online configurator streamlines the ability to select and configure our products and to create quotes for you and your customers. To install the HP Network Discovery Tool follow these steps: From a PC (running Windows Vista SP2, Windows 7 SP1, 8, 2008 SP2 or R1 SP1, or later), type in the URL. for the HP Network Discovery Tool into a browser’s address field and press Enter. When asked, open.
Run the HP Network Discovery Tool shortly after powering on newly installed devices. By default, only new HP Networking devices will display. Use the filter drop-downs to specify device age, type, etc. Double-click on a device to start its web user interface.
Hp Network Discovery Tool Free
For additional information, visit the HP Network Discovery Tool’s internal help page.